Photo Flash SRK

• Longer shelf-life
• Abrasion-resistant and reclaims easily
• Very good resolution

100 mesh count & below:

• Apply stencil twice (2x) on printing side and twice (2x) on substrate side.
  

Printing side (1) -> Substrate side (1) -> Printing side (1) -> Substrate side (1)

120 mesh count & above:

• Apply stencil twice (2x) on printing side and once (1x) on substrate side.

Printing side (1) -> Substrate side (1) -> Printing side (1)

Compatible with solvent-based inks

Compatible with any mesh counts.

To avoid light exposure for the sensitizer powder during the mixing process, either utilize a dark container or choose a see-through container and then cover it entirely with a dark plastic bag.

1. Sensitizer solution: Dissolve sensitizer (0.60%) with 0.50% of clean water. Then add 1.80% pigment (adds color to a transparent stencil). Stir well.

2. Add in the sensitizer solution into the Photo Flash stencil emulsion.

3. Stir well and de-air the mixture for 1-2 hours before use.

Exposure time will depend on the light source/wattage and distance of screen from the light source.

• Let the stencil dry untouched at room temperature or use dryer.
• Conduct a stencil calculator test for accurate time exposure.
  

Wash materials used with soap and water. Observe all local regulations when disposing of this substance.

Store tightly covered at temperatures between 10ºC – 30ºC (50ºF – 86ºF) and a relative humidity between that of 25% to 70%. Keep away from direct sunlight or high temperatures.

[EN]

Instruction

• Stir well before using ink.
• Pre-test fabric compatibility prior to mass production.
• Wash test must be carried out 24 hours after printing.

Precaution

• Wear protective gloves if there is continual contact of ink for sensitive skins.
• Avoid any contact with eyes.
• Wash hands thoroughly at the end of work.
• Do not swallow.
• Keep out of reach of children.

Storage and Handling

• Ensure good ventilation at the workplace.
• Close lid after use.
• Dispose of the waste according to your local regulation.

[FR]

Instruction

• Mélanger avant utilisation.
• Tester sur échantillonnage avant
  production en masse.
• Lavage 24 heures après impression.

Precaution

• Porter des gants si il y a contact prolonge avec la peau si peaux sensibles.
• Eviter tout contact avec les yeux.
• Nettoyer vos mains après utilisation.
• Ne pas avaler.

Entreposage et Manutention

• A utiliser dans une pièce aérée.
• Refermer couvercle après usage.
• Veuillez disposer du produit suivant les normes en vigueur dans votre pays.