Arbitrend Glowlight Natural is a textile ink base with glow-in-the-dark properties, best suited for application on light-colored substrates or as a top print layer over a white or light-colored underbase.
Highlight
Soft-hand feel with good washing fastness
Fashion-base effects with a glow-in-the-dark finish
Good washing fastness
Good printability and stability on screen
Easy cleanup with soap and water
Application
Direct to textile printing. For cut-piece articles and ready-to-wear.
Material Compatibility
100% Cotton
50/50 Cotton-polyester blend/synthetic fiber
Calico/Canvas
Screen Mesh
80T-120T, monofilament
Instruction
The printing process can be done either manual or via automatic screen-printing.
In halftone print, one [1] stroke is ideal but two [2] strokes are acceptable.
On dark ground substrates, print white under base and Arbitrend Glow Light Natural as top print.
Curing is recommended to greatly increase washing fastness. Curing will also give the print a glossier print output.
Recommended Pigment Load
Not recommended
Recommended Curing Parameters
Drying time : 10 seconds
Temperature : 110ºC (230ºF)
Equipment : Heat press/oven/flash cure
Pre-curing : Heat gun
Time and temperature may vary depending on the curing equipment used.
Clean Up
Wash materials used with soap and water. Observe all local regulations when disposing of this substance.
Storage and Handling
Store tightly covered at temperatures between 10ºC – 30ºC (50ºF – 86ºF) and a relative humidity between that of 25% to 70%. Keep away from direct sunlight or high temperatures.
Label Instruction
[EN]
Instruction
Stir well before using ink.
Pre-test fabric compatibility prior to mass production.
Wash test must be carried out 24 hours after printing.
Precaution
Wear protective gloves if there is continual contact of ink for sensitive skins.
Avoid any contact with eyes.
Wash hands thoroughly at the end of work.
Do not swallow.
Keep out of reach of children.
Storage and Handling
Ensure good ventilation at the workplace.
Close lid after use.
Dispose of the waste according to your local regulation.
[FR]
Instruction
Mélanger avant utilisation.
Tester sur échantillonnage avant
production en masse.
Lavage 24 heures après impression.
Precaution
Porter des gants si il y a contact prolonge avec la peau si peaux sensibles.
Eviter tout contact avec les yeux.
Nettoyer vos mains après utilisation.
Ne pas avaler.
Entreposage et Manutention
A utiliser dans une pièce aérée.
Refermer couvercle après usage.
Veuillez disposer du produit suivant les normes en vigueur dans votre pays.
This technical data sheet does not replace the Safety Data Sheet and should be used according to its recommended purpose. Any person using the product other than that specifically recommended does so at his own risk.
While we endeavor to ensure that all recommendations about our products are correct, many factors may affect the application of the product. It is advised that the quality of the substrate, the condition of the curing method, and other printing characteristics brilliance before mass production.
Disclaimer
The information and recommendation in this publication are to the best of our knowledge, information, and belief accurate at the date of publication. Nothing herein is to be construed as a warranty, express or implied.
In all cases, it is the responsibility of users to determine the applicability of such information or the suitability of any products for their own particular purpose. Therefore, we do not accept any liability whatsoever or howsoever arising for the performance of the product or for any loss or damage incurred out of the use of the product.
The information contained herein is liable to modification from time to time in light of continuous product development or improvements.
Choosing a selection results in a full page refresh.
